Prediction of Sludge and Varnish Formation in Base-stock Lubricant Using an Experimental Package

Document Type : Research Article

Authors

1 Thermodynamics Research Laboratory, School of Chemical Engineering, Iran University of Science and Technology, Tehran

2 Thermodynamics Research Laboratory, School of Chemical Engineering, Iran University of Science and Technology

Abstract

One of the most prevalent problems in the application of lubricants and hydraulic oils is sludge and varnish formation from lubricant degradation. It is believed that thermal degradation is the main reason for sludge formation in lubrication systems. In this study, base-stock lubricant (group I API) underwent the thermal degradation within a temperature range of 90 to 150°C for a period of 1 to 48 hours. In order to obtain a clear justification about lubricant degradation, a new analysis package of experiments consists of FTIR (Fourier Transform Infrared Spectroscopy), viscosity, TAN (Total Acid Number), IFT (Interfacial Tension measurement) and UC (Ultra-Centrifuge) test has been conducted. The results showed that the amount of sludge increases with temperature. Furthermore, all obtained results were analyzed theoretically. We found that when the surface tension suddenly decreases, the amount of sludge in the lubricant has reached its dangerous limit. Since the results of these analyses were a good predictor of sludge production, it can be claimed that the proposed package can be applied for prediction of sludge formation conditions.

Keywords

References

[1] Rauscher, M.S., Tremmel, A.J., Schardt, M., Koch, A.W., 2017. Non-Dispersive Infrared Sensor for Online Condition Monitoring of Gearbox Oil, Sensors, 17 (2), 399-407.  https://doi.org/10.3390/s17020399
[2] Fitch, J.C., Gebrain, S., 2006. Review of Degradation Mechanisms Leading to Sludge and Varnish in Modern Turbine Oil Formulations, Journal of ASTM International, 3 (8), 1. https://doi.org/10.1520/JAI13504
[3] Ingold, K.U., 1961. Inhibition of the Autoxidation of Organic Substances in the Liquid Phase, Chemical Reviews, 61,563-589. https://doi.org/10.1021/cr60214a002
[4] Stark, M.S., Wilkinson, J.J., Smith, J.R.L., Alfahad, A., Pochopien, B.A., 2011. Autoxidation of Branched Alkanes in the Liquid Phase, Industrial & Engineering Chemistry Research, 50, 817-823. https://doi.org/10.1021/ie101695g
[5] Gatto, V.J., Moehle, W.E., Cobb, T.W., Schneller, E.R., 2006. Oxidation Fundamentals and Its Application to Turbine Oil Testing, Journal of ASTM International, 3(4), 1-20. https://doi.org/10.1520/JAI13498
[6] Migdal, C.A., 2003. Antioxidants, in: Rudnick LR (Ed.), Lubricant Additives Chemistry and Applications, Marcel Dekker Inc, New York.
[7] Rasberger, M., 1997. Oxidative Degradation and Stabilization of Mineral Oil Based Lubricants, in: Motier RM, Orszulik ST, (Eds.). Chemistry and Technology of Lubricants, Blackie Academic and Professional, London.
[8] Colclough, T., 1993. Lubricating Oil Oxidation and Stabilization, in: Scott G. (Ed.), Atmospheric Oxidation and Antioxidants, Elsevier Science Publishers, Amsterdam.
[9] Shlyapnikov, Y.A., 1981. Antioxidant Stabilization of Polymers, Russian Chemical Reviews, 50, 581-600. https://doi.org/10.1070/RC1981v050n06ABEH002652
[10] Scott, G., 1965. Atmospheric Oxidation and Antioxidants, Elsevier Publishing Company, Amsterdam.
[11] March, J., 1985. Advanced Organic Chemistry, 3nd ed., John Wiley & Sons Inc, New York.
[12] Thompson, B.T., Livingstone, G., 2004. Using Quantitative Spectrophotometric Analysis as a Predictive Tool to Measure Varnish Potential, Lubrication Excellence 2004 Conference, March 23-25, Nashville, USA.
[13] Livingstone, G., Thompson, B., 2005. New Varnish Test Improves Predictive Maintenance Program,  Lubrication Excellence 2005 Conference, April 25-29, San Antonio, USA.
[14] Livingstone, G., 2003. Detecting Thermal Failure and Varnish Potential, Lubrication Excellence 2003 conference, April 1-3, Houston, Texas, USA.
[15] Yano, A., Watanabe, S.H., Miyazaki, Y., Tsuchiya, M., Yamamoto, Y., 2004. Study on Sludge Formation during the Oxidation Process of Turbine Oils, Tribol. Trans. 47, 111-122. https://doi.org/10.1080/05698190490278985
[16] Kouame, S.D., Liu, E., 2014. Characterization of fully and partially additized lubricant deposits by Temperature Programmed Oxidation, Tribology International. 72, 58–64. https://doi.org/10.1016/j.triboint.2013.11.001
[17] Sinha, S., Agarwal, A.K., 2010. Experimental investigation of the effect of biodiesel utilization on lubricating oil degradation and wear of a transportation CIDI engine. Journal of Engineering for Gas Turbines and Power. 132 (4), 1-9. https://doi.org/10.1115/1.3077659
[18] Perez, J.M., 1999. Oxidative properties of lubricants using thermal analysis, Thermochimica Acta. 357–358, 47–56. https://doi.org/10.1016/S0040-6031(00)00367-1
[19] Kurre, S.K., Garg, R., Pandey, S., 2017. A review of biofuel generated contamination, engine oil degradation and engine wear, Biofuels. 8(2), 273-280. https://doi.org/10.1080/17597269.2016.1224291
[20] Altaie, M.A.H., Janius, R.B., Yunus, R., Taufiq-Yap, Y.H, Zakaria, R., 2016. Degradation of enriched biodiesel under different storage conditions, Biofuels. 8(2), 181-186. https://doi.org/10.1080/17597269.2016.1215070
[21] Coates, J.P., Setti, L.C., 1986. Infrared Spectroscopic Methods for the Study of Lubricant Oxidation Products, ASLE Transactions. 29(3), 394-401. https://doi.org/10.1080/05698198608981701
[22] Liu, Z., Wang, H., Zhang L., Sun, D., Cheng, L., Pang, C., 2016. Composition and degradation of turbine oil sludge, Journal of Thermal Analysis and Calorimetry. 125(1), 155–162. https://doi.org/10.1007/s10973-015-5200-1
[23] Fitch, J.C., Gebarin, S., 2006. Sludge and varnish in turbine systems, Practicing Oil Analysis. 5, 28–36.
[24] Shima, M., Kumazaki, O., Hashimoto, K., Yoshida, T., 2000. Development of lubricant deterioration evaluation method using chemical analysis; Sanka boshizai no kagaku bunseki ni yoru tabinyu rekka hanteiho no kaihatsu, Karyoku Genshiryoku Hatsuden. 51, 108–112. https://www.osti.gov/etdeweb/biblio/20092463 
[25] Hussain, S.K.A., Usman, M., Umer, J., Farooq, M., Noor, F., Anjum, R., 2022. A novel analysis of n-butanol–gasoline blends impact on spark ignition engine characteristics and lubricant oil degradation, Energy Sources, Part A: Recovery, Utilization, and Environmental Effects. 1-15. https://doi.org/10.1080/15567036.2022.2036874
[26] Dörr, N., Agocs, A., Besser C., Ristić A., Frauscher M., 2019. Engine Oils in the Field: A Comprehensive Chemical Assessment of Engine Oil Degradation in a Passenger Car. Tribology Letter. 67, 68. https://doi.org/10.1007/s11249-019-1182-7
[27] Jamil, M.K., Akhtar, M., Farooq, M., Abbas, M.M., Saad., Khuzaima, M., Ahmad, K., Kalam, M.A., Abdelrahman, A., 2022. Analysis of the Impact of Propanol-Gasoline Blends on Lubricant Oil Degradation and Spark-Ignition Engine Characteristics. Energies. 15, 5757. https://doi.org/10.3390/en15155757
[28] Ahme, L., Kuhn, E., Canto, M.A.D., 2022. Experimental Study on the Expended Energy on Structural Degradation of Lubricating Greases. Tribology Letter. 70, 81. https://doi.org/10.1007/s11249-022-01622-2
[29] Ribeiro, F.C.P, Oliveira, A.S., Araújo, A., Marinho, W., Schneider, M.P., Pinto, L., Gomes, A.A., 2019. Detection oxidative degradation in lubricating oil under storage conditions using digital images and chemometrics. Microchemical Journal. 147, 622. https://doi.org/10.1016/j.microc.2019.03.087
[30] Sasaki, A., Uchiyama, S., Yamamoto, T., 1999. Generation of Static Electricity during Oil Filtration. Lubrication Engineering. 55(9), 24-27.
[31] Sasaki, A., Uchiyama, S., Yamamoto, T., 1999. Free Radicals and Oil Auto-Oxidation Due to Spark Discharges of Static Electricity. Lubrication Engineering. 55 (9), 24.
 [32] Gunsel, S., Lockwood, F.E., 1995. The Influence of Copper-Containing Additives on Oil Oxidation and Corrosion, Tribology Transactions. 38(3), 485-496. https://doi.org/10.1080/10402009508983434
[33] Lahijani, J., Lockwood, F.E., Klaus, E.E., 1982. The Influence of Metals on Sludge Formation. Tribology Transactions. 25, 25-32. https://doi.org/10.1080/05698198208983060
[34] Sasaki, A., Uchiyama, S., Kawasaki, M., 2008. Varnish Formation in the Gas Turbine Oil Systems, Journal of ASTM International. 5(2), 1-12. https://doi.org/10.1520/JAI101419
 
Chemical Process Design
Volume 1, Issue 2
December 2022
Pages 47-58

Files

Share

How to cite

Statistics